Lower Arm Bushing: Installation

WARNING: This page is about a different car, the 2009 Mercury Sable, 2009 Ford Taurus X, and 2009 Ford Taurus. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The Drive Pinion Bearing Cone Remover is used to clamp and hold the lower arm while installing the bushing.

Install the Drive Pinion Bearing Cone Remover onto the lower arm.

Fig 1: Identifying Special Tool (205-D002)

Courtesy of FORD MOTOR CO.

Transfer the index mark to the new lower arm bushing.

NOTE: The Drive Pinion Bearing Cone Remover is used to clamp and hold the lower arm while installing the bushing.

Align the index marks and using the Drive Pinion Bearing Cone Remover, press and adapters, install a new lower arm bushing.

Fig 2: Identifying Special Tool (205-D002)

Courtesy of FORD MOTOR CO.

Install the lower arm. For additional information, refer to Lower Arm .