LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 158 (Driveline System - General Information) >> Diagnosis And Testing >> Driveline System >> Preliminary Diagnosis >> Wheel Hub Face Runout

Wheel Hub Face Runout

WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the special tool on the wheel hub face, as close to the outer edge as possible. Zero the indicator to allow the pointer to deflect either way.
    Fig 1: Measuring Wheel Hub Face Runout
    G03897229Courtesy of FORD MOTOR CO.
  2. Rotate the hub one full turn and note the maximum and minimum readings. The difference between the maximum and minimum readings will be the total face runout. The runout must not exceed 0.254 mm (0.010 inch).
scientia non olet · About LEMON Manuals