LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1547 (Safety Belt System) >> General Procedures >> Safety Belt Tongue Rotated On Belt

Safety Belt Tongue Rotated On Belt

WARNING: This page is about a different car, the 2009 Mercury Grand Marquis and 2009 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
  1. Grasp the belt tongue and pull the belt webbing down to form a loop through the slot in the tongue.
    2. Fig 1: Forming A Belt Webbing Loop Through Slot In Tongue
    GF0000113Courtesy of FORD MOTOR CO.
  2. Rotate and fold the belt webbing over itself within the slot to remove the twist.
  3. Pull the excess belt webbing back through the slot in the belt tongue.
  4. Pull the excess belt webbing through the slot.
  5. The safety belt tongue should face inward when completed.
    6. Fig 2: Safety Belt Tongue Facing Inward
    GF0000115Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals