Bumper Bracket - Rear: Removal
WARNING: This page is about a different car, the 2009 Mercury Grand Marquis and 2009 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Never apply heat to the bumper isolator and bracket. Heat could cause the material inside the bumper isolator and bracket to expand and leak. Heat may also crack the metal housing. Always remove the bumper isolator and bracket before carrying out body frame service near them.
- Remove the rear bumper. For additional information, refer to Bumper - Rear .
- Remove the bolt and the rear bumper bracket.
NOTE:
LH shown in illustration, RH similar.