LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1542 (Electronic Suspension - Vehicle Dynamic Suspension System) >> Removal And Installation >> Air Suspension Switch >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2009 Mercury Grand Marquis and 2009 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Any air spring which is unfolded must be refolded prior to being installed in a vehicle. Refer to the appropriate procedures. An incorrectly folded air spring could rupture, altering the handling characteristics of the vehicle. If a vehicle has been driven with an incorrectly folded air spring, a new air spring must be installed. Failure to follow these instructions may result in serious injury to vehicle occupant(s).
  1. Turn the air suspension service switch to the OFF position.
  2. Peel back the luggage compartment trim in the following sequence.
    1. Remove the pushpins.
    2. Peel back the luggage compartment trim.
  3. Remove the air suspension switch in the following sequence.
    1. From behind the quarter panel reinforcement, depress the clips.
    2. Remove the air suspension switch.
  4. Disconnect the air suspension switch electrical connector.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals