LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1532 (Engine Mechanical) >> In-Vehicle Servicing >> Engine Oil Pressure (EOP) Switch >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2009 Mercury Grand Marquis and 2009 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
    WARNING: Before servicing a vehicle equipped with a fire suppression system, depower the system by following the procedure in FIRE SUPPRESSION SYSTEM article. Failure to follow the instructions may result in serious personal injury.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING article.
  2. Disconnect the Engine Oil Pressure (EOP) switch electrical connector and remove the EOP switch.
    • To install, tighten to 14 Nm (124 lb-in), then tighten an additional 180 degrees.
    3. WARNING: If the vehicle is equipped with a fire suppression system, repower the system. For important safety warnings and procedures, refer to FIRE SUPPRESSION SYSTEM article. Failure to follow these instructions may result in serious personal injury.
  3. To install, reverse the removal procedure. If equipped with fire suppression system, repower the system.
scientia non olet · About LEMON Manuals