Removal And Installation
WARNING: This page is about a different car, the 2009 Mercury Grand Marquis and 2009 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING article.
- Remove the generator. For additional information, refer to CHARGING SYSTEM - GENERAL INFORMATION article.
- Install the Engine Lifting Bracket.
- Install the Engine Support Bar.
- Remove the RH and LH lower engine mount nuts.
- To install, tighten to 90 Nm (66 lb-ft).
- Using the Engine Support Bar, raise the engine.
- Remove the 3 RH engine mount bolts.
- To install, tighten to 70 Nm (52 lb-ft).
- Remove the RH engine mount.
- To install, reverse the removal procedure. If equipped with fire suppression system, repower the system
WARNING:
Before servicing a vehicle equipped with a fire suppression system, depower the system by following the procedure in FIRE SUPPRESSION SYSTEM
article. Failure to follow the instructions may result in serious personal injury.
WARNING:
If the vehicle is equipped with a fire suppression system, repower the system. For important safety warnings and procedures, refer to FIRE SUPPRESSION SYSTEM
article. Failure to follow these instructions may result in serious personal injury.