LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1531 (Automatic Transmission) >> In-Vehicle Servicing >> Reverse Servo Assembly >> Removal

Reverse Servo Assembly: Removal

WARNING: This page is about a different car, the 2009 Mercury Grand Marquis and 2009 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
    WARNING: Before servicing a vehicle equipped with a fire suppression system, depower the system by following the procedure in FIRE SUPPRESSION SYSTEM article. Failure to follow the instructions may result in serious personal injury.
  1. Remove the main control valve body. For additional information, refer to Main Control Valve Body .
  2. Using the Servo Piston Remover/Installer, remove the reverse band servo retaining ring.
    1. Compress the servo spring.
    2. Remove the reverse band servo retaining ring.
    3. Fig 1: Removing Reverse Band Servo Retaining Ring Using Special Tool
    GF0003519Courtesy of FORD MOTOR CO.
  3. Remove the reverse servo assembly.
    1. Remove the reverse band servo cover.
    2. Remove the reverse band servo piston and rod.
    3. Remove the reverse band servo spring.
    4. Fig 2: Removing Reverse Servo Assembly
    GF0003520Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals