LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1531 (Automatic Transmission) >> In-Vehicle Servicing >> 1-2 Accumulator >> Removal

1-2 Accumulator: Removal

WARNING: This page is about a different car, the 2009 Mercury Grand Marquis and 2009 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
    WARNING: Before servicing a vehicle equipped with a fire suppression system, depower the system by following the procedure in FIRE SUPPRESSION SYSTEM article. Failure to follow the instructions may result in serious personal injury.
  1. Drain the transmission fluid and remove the transmission fluid pan and filter. For additional information, refer to Fluid Pan, Gasket and Filter .
  2. Compress the 1-2 accumulator cover and remove the accumulator piston retaining ring.
    3. Fig 1: Locating Accumulator Piston Retaining Ring
    G03888654Courtesy of FORD MOTOR CO.
    NOTE: Note the location of the 1-2 accumulator springs for reference during assembly.
  3. Remove the 1-2 accumulator.
    1. Remove the 1-2 accumulator cover.
    2. Remove the inner and outer lower 1-2 accumulator spring.
    3. Remove the accumulator piston.
    4. Remove the upper 1-2 accumulator spring.
    4. Fig 2: Identifying 1-2 Shift Accumulator Assembly
    GF0003533Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals