Accelerator Pedal and Bracket: Removal

WARNING: This page is about a different car, the 2009 Mercury Grand Marquis and 2009 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.

All vehicles

NOTE: To prevent setting DTCs, make sure the ignition switch is in the OFF position prior to disconnecting the accelerator pedal electrical connectors.

Disconnect the accelerator pedal sensor electrical connector.

NOTE: The accelerator pedal motor electrical connector is present on all vehicles, including vehicles with fixed pedal and bracket assemblies. The electrical connector on the fixed pedal assemblies are non-working and plugged into an empty receptacle connector.

Disconnect the accelerator pedal motor electrical connector.

Vehicles with adjustable accelerator pedal and bracket

Disconnect the accelerator pedal motor drive cable connector.

All vehicles

Remove the 3 accelerator pedal and bracket nuts.
Remove the accelerator pedal and bracket assembly.