Adjustable Pedal Indexing

WARNING: This page is about a different car, the 2009 Mercury Grand Marquis and 2009 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The adjustable pedal system must be indexed whenever the brake pedal assembly or the accelerator pedal assembly is repaired or component damage may occur.

NOTE: Make sure the electrical connector is connected to the adjustable pedal motor.

Disconnect the adjustable pedal motor drive cable from the brake pedal drive.

Fig 1: Adjustable Pedal Motor Drive Cable At The Brake Pedal Drive

Courtesy of FORD MOTOR CO.

Operate the accelerator pedal to the full rearward position.
Connect the adjustable pedal motor drive cable to the adjustable brake pedal drive.

Fig 2: Adjustable Pedal Motor Drive Cable At The Brake Pedal Drive

Courtesy of FORD MOTOR CO.

Operate the adjustable pedal motor to align the adjustable brake pedal indexing marks.

Fig 3: Aligning The Adjustable Brake Pedal Indexing Marks

Courtesy of FORD MOTOR CO.

Disconnect the adjustable pedal motor drive cable from the adjustable brake pedal assembly.

Fig 4: Adjustable Pedal Motor Drive Cable At The Brake Pedal Drive

Courtesy of FORD MOTOR CO.

Operate the adjustable accelerator pedal to the full forward position.
Connect the adjustable pedal motor drive cable to the adjustable brake pedal drive.

Fig 5: Adjustable Pedal Motor Drive Cable At The Brake Pedal Drive

Courtesy of FORD MOTOR CO.

Check that the brake and accelerator pedals can adjust at least 50 mm (1.96 in) from the base position.