Section 1503 (Tires & Wheels)
WARNING: This page is about a different car, the 2009 Mercury Grand Marquis and 2009 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Description & Operation
- Diagnostic Tests
- Wheels & Tires
- Tire Pressure Monitoring System
- Notes
- Principles of Operation
- Inspection & Verification
- Symptom Chart
- Pinpoint Tests
- Pinpoint Test E: Tire Pressure Monitoring System (TPMS) Indicator ON Solid When the Ignition Key is Turned to the ON Position and Message Center (if equipped) Displays LOW TIRE PRESSURE
- Pinpoint Test F: The Driver Door Module (DDM) Will Not Enter Training Mode
- Pinpoint Test G: TPMS Indicator FLASHES For 70 Seconds and Then Remains ON Solid When the Ignition Key is Turned to the ON Position, the Message Center (if equipped) Displays TIRE PRESSURE SENSOR FAULT or TIRE PRESSURE MONITOR FAULT and DTC B2872 or B287A is Present
- Pinpoint Test H: DTC B106A - Pressure Sensor Range Bit Incorrect State
- Pinpoint Test I: DTC B106B - Tire Pressure Sensor Low Battery
- General Procedures
- Removal & Installation
- Disassembly & Assembly
- Disassembly & Assembly Of Subassemblies