Shock Absorber and Spring Assembly - AWD: Removal
WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can result in major service expense. A new part with the same part number, or an equivalent part, must be installed if installation is necessary. Do not use a new part of lesser quality or substitute design. Torque values must be used as specified to make sure of correct retention of these parts.
- Measure the distance from the center of the hub to the lip of the fender with the vehicle in a level, static ground position (curb height).
- Remove the interior trim to access the upper shock absorber-to-mount nut.
- Remove and discard the upper shock absorber-to-mount nut.
- Remove the wheel and tire assembly. For additional information, refer to WHEELS & TIRES .
- Remove the rear brake caliper anchor plate bolts and position the brake caliper assembly aside.
- To install, tighten to 100 Nm (74 lb-ft).
- Raise the vehicle.
- Position a V-topped transmission jack under the wheel knuckle at the trailing arm and wheel knuckle attachment point, then raise it enough to compress the shock absorber and spring.
- Remove and discard the trailing arm-to-knuckle bolt.
- Loosen the trailing arm-to-subframe bolt.
- Remove and discard the lower arm-to-knuckle bolt.
- Lower the transmission jack.
- Remove and discard the lower shock absorber and spring assembly-to-knuckle bolt.
- Carefully push the lower shock absorber and spring assembly off of the lower arm.
- Remove the shock absorber and spring assembly.
CAUTION:
When removing the rear brake caliper, never allow it to hang from the brake caliper flexible hose. Provide a suitable support.