Removal And Installation
WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the 8 ignition coil electrical connectors.
- Remove the 8 ignition coil bolts.
- To install, tighten to 5 Nm (44 lb-in).
- Remove the 8 ignition coils.
- To install, reverse the removal procedure.
- Apply a light film of brake caliper grease to the inside of the coil boots before installation.
NOTE:
When removing the ignition coils, a slight twisting motion will break the seal and ease removal.