LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1489 (Manual Transmission - Tr3650) >> In-Vehicle Servicing >> Output Shaft Speed (OSS) Sensor >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
  2. Disconnect the OSS electrical connector.
    3. Fig 1: Disconnecting Electrical Connector
    GF0001088Courtesy of FORD MOTOR CO.
  3. Remove the OSS sensor bolt, then remove OSS sensor.
    • To install, tighten to 10 N.m (89 lb-in).
    4. Fig 2: Locating Output Shaft Speed (OSS) Sensor
    GF0015805Courtesy of FORD MOTOR CO.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals