Input Shaft and Bearing: Disassembly

WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.

Using the Pinion Bearing Cone Remover and a press, remove the input shaft bearing.

Fig 1: Removing Input Shaft Bearing

Courtesy of FORD MOTOR CO.

Remove the input shaft bearing cup and the end play selective shims.

Fig 2: Locating Input Shaft Bearing Cup

Courtesy of FORD MOTOR CO.

Remove and discard the input shaft seal.
Inspect the input shaft for damage or wear.
- Inspect the surface of the input shaft in the area of the bearing race to make sure it is smooth and free of burrs.
- Inspect the splines for nicks. Install a new input shaft as necessary.