Countershaft Bearing: Disassembly

WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.

Using the Drive Pinion Bearing Cone Remover, press and remove the countershaft bearing from the countershaft.

Fig 1: Identifying Special Tool 205-D002

Courtesy of FORD MOTOR CO.

NOTE: Failure to correctly support the case during bearing race removal will result in permanent distortion of the case.

NOTE: Remove the front countershaft bearing cup if damaged, worn or a new countershaft bearing is being installed.

Using the Bearing Tube Remover/Installer, Input Shaft Bearing Installer, Mainshaft Front Bearing Installer and the Bearing Installer, press and remove the bearing cup and the countershaft front bearing seal from the case.

Fig 2: Removing Bearing Cup And Countershaft Front Bearing Seal From Case

Courtesy of FORD MOTOR CO.