LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1485 (Engine Mechanical - 4.6L (3V)) >> In-Vehicle Servicing >> Oil Level Indicator and Tube >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
  2. Detach the evaporative emissions (EVAP) canister purge valve from the bracket and position aside.
  3. Remove the oil level indicator and tube bolt.
    • To install, tighten to 10 N.m (89 lb-in).
  4. Remove the oil level indicator and tube from the cylinder block.
    • Discard the O-ring seal.
    5. NOTE: Lubricate the new oil level indicator tube O-ring seal with clean engine oil prior to installation.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals