LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1482 (Engine Mechanical - 5.4L (4V)) >> In-Vehicle Servicing >> Flywheel >> Removal

In-Vehicle Servicing: Flywheel: Removal

WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the clutch. For additional information, refer to CLUTCH .
  2. Remove the 8 flywheel bolts.
    3. NOTE: The flywheel is a press fit on the crankshaft pilot. Do not use screwdrivers or prybars to remove the flywheel or damage to the flywheel or engine may occur.
  3. Remove the flywheel.
    • Install 2 of the removed flywheel bolts in the 2 holes shown on the flywheel flange.
    • Tighten the 2 bolts evenly to push the flywheel off the crankshaft pilot.
    4. Fig 1: Identifying Flywheel Bolts
    GF0046355Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals