Selector Lever Knob: Installation

WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.

Connect the TC switch electrical connector.
Fold the TC switch wire into the selector shaft channel to keep the harness from contacting the sliding mechanisms.

CAUTION: Tightening the screw over 3 Nm (27 lb-in) may damage the selector lever assembly.

Align the selector lever knob base screw hole with the selector shaft and install the screw.
- Tighten to 3 Nm (27 lb-in).

Fig 1: Locating Screw From Knob Base

Courtesy of FORD MOTOR CO.

Install the transmission selector lever assembly in the vehicle. For additional information, refer to Selector Lever .