Low Speed Windshield Wipers

WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.

When the wiper/wash switch is set to the LOW-speed position, it supplies ground to the internal windshield wiper motor module low-speed input and the windshield wiper motor operates at low speed. During LOW-speed operation, the internal run/park relay is activated by the microprocessor and supplies 12 volts to the low-speed brush of the windshield wiper motor. The run/park relay coil ground is controlled by the internal windshield wiper motor module based on inputs received from the windshield wiper/washer switch. When the switch is placed in the OFF position, the motor continues to operate until the motor returns to the PARK position and the internal Hall-effect sensor senses the motor magnet. The output to the run/park relay deactivates the relay and disconnects the voltage to the motor.

Since the run/park relay is controlled by the internal windshield wiper motor microprocessor, the wipers will only operate in high-speed mode if the internal windshield wiper motor module fails, and will not automatically park when the windshield wiper/washer switch is turned to the OFF position. This is due to the run/park and high/low relay coils being directly hard-wired to the switch in high speed. The diode prevents current flow through the high/low relay coil so the relay remains in the normally closed LOW-speed position.