Applique - Rear, Roof: Removal

WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Always wear eye protection when servicing a vehicle. Failure to follow this instruction may result in serious personal injury.

WARNING: Wear protective gloves when handling components or parts that have pointed or sharp edges. Failure to follow this instruction may result in serious personal injury.

NOTE: The rear roof applique will be damaged during the removal process. Install a new rear roof applique.

Remove the glass roof panel.
Using a suitable prying tool, pry up on the corners of the moulding to gain access to the adhesive.

Fig 1: Prying Up On Corners Of Moulding
Courtesy of FORD MOTOR CO.

NOTE: Lubricate the urethane adhesive with water to aid the Deluxe Windshield Removal Tool when cutting the urethane adhesive.

Fig 2: Urethane Adhesive

Courtesy of FORD MOTOR CO.

Using the Deluxe Windshield Removal Tool, begin cutting from either end towards the middle of the car. For additional information on the urethane adhesive path, refer to the illustration.
Rotate the moulding up and forward while moving toward the interior of the car. Bend the moulding as necessary to gain access to the adhesive.
Remove the moulding and discard.