LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1451 (Steering Column) >> Removal And Installation >> Steering Column Shroud >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: The instrument cluster finish panel is held in place with retaining clips that are attached to the bezel.
  1. Remove the instrument cluster finish panel.
  2. Remove the floor console finish panel.
  3. Remove the LH A-pillar lower trim panel.
  4. Remove the left center stack wing.
  5. Remove the 2 screws and the steering column opening cover.
    • Disconnect the headlamp and courtesy light switch electrical connectors.
  6. Remove the 4 bolts and the steering column opening cover reinforcement.
    • To install, tighten to 9 Nm (80 lb-in).
    7. NOTE: Release the upper steering column shroud by carefully pressing the sides inward.
  7. Remove the 3 lower steering column shroud screws and the shroud.
  8. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals