Intake Air Temperature 2 (IAT2) Sensor - 5.4L (4V): Installation
WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
- Install the IAT2 sensor. Tighten the IAT2 sensor in 2 stages:
- Stage 1: Tighten the IAT2 sensor to 15 Nm (11 lb-ft).
- Stage 2: Tighten the IAT2 sensor until it is aligned as shown.
NOTE: During Stage 2, do not tighten the IAT2 sensor more than one full turn and do not rotate the IAT2 sensor counter clockwise after tightening. - Connect the IAT2 sensor electrical connector.