Wheel Speed Sensor Ring - Rear: Installation
WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
- Using the Axle Bearing/Seal Plate and the Wheel Speed Sensor Ring Installer, align the rear anti-lock brake sensor indicator to the rear axle shaft.
- Using the Axle Bearing/Seal Plate and the Wheel Speed Sensor Ring Installer, press the rear anti-lock brake sensor on the rear axle shaft to specification.
- Install the rear axle shaft. For additional information, refer to REAR DRIVE AXLE/DIFFERENTIAL - FORD 7.5-INCH RING GEAR .
Fig 1: Aligning Rear Anti-Lock Brake Sensor Indicator To Rear Axle Shaft Using Special Tools 205-090 & 206-041
Fig 2: Pressing Rear Anti-Lock Brake Sensor On Rear Axle Shaft Using Special Tools 205-090 & 206-041