Removal And Installation
WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
- Remove the floor console. For additional information, refer to INSTRUMENT PANEL AND CONSOLE article.
- Release the tension on the parking brake cable. For additional information, refer to Parking Brake Cable Tension Release in this article.
- Disconnect the front parking brake cable from the 2 rear parking brake cables at the equalizer and release the front cable from the body bracket.
- Disconnect the parking brake switch electrical connector.
- Remove the 2 nuts from the parking brake control.
- To install, tighten to 17 Nm (13 lb-ft).
- Remove the 2 bolts from the parking brake control.
- To install, tighten to 30 Nm (22 lb-ft).
- Remove the parking brake control.
- Position the cable and equalizer through the floorpan.
- To install, reverse the removal procedure.
- Adjust the parking brake cable tension. For additional information, refer to Parking Brake Cable Adjustment in this article.