Rear Brake Caliper: Removal
WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that has been previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of serious personal injury.
WARNING:
Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.
CAUTION:
Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with water.
- Remove the wheel and tire. For additional information, refer to WHEELS AND TIRES article.
- Remove the retaining clip and the parking brake cable and conduit from the brake caliper.
- Remove the brake caliper flow bolt and discard the 2 copper washers.
- Remove the 2 brake caliper guide pin bolts and the brake caliper.
- Inspect the brake caliper.
- If leaks or a damaged piston boot are found, install a new brake caliper.