Rear Brake Caliper Anchor Plate: Installation
WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
- Clean any residual thread lock compound, and any other foreign material, from the threads of the brake caliper anchor plate.
- Position the brake caliper anchor plate and install 2 new anchor plate bolts.
- Tighten to 103 Nm (76 lb-ft).
- Install the brake pads. For additional information, refer to Brake Pads .
CAUTION:
In order for the brake caliper anchor plate bolts to attain the proper clamp load when installed, the residual thread lock compound must be cleaned out of the bolt threads of the anchor plate.