Front Brake Caliper - 4.0L SOHC and 4.6L (3V): Installation
WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
- Position the brake caliper and install 2 new guide pin bolts.
- Tighten to 34 Nm (25 lb-ft).
- Using 2 new copper washers, position the brake flexible hose on the brake caliper and install the brake caliper flow bolt.
- Tighten to 40 Nm (30 lb-ft).
- Bleed the brake system. For additional information, refer to BRAKE SYSTEM - GENERAL INFORMATION article.
- Install the wheel and tire. For additional information, refer to WHEELS AND TIRES article.