LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1437 (Power Steering System) >> Removal And Installation >> Power Steering Pump Pulley - 4.0L >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the air cleaner outlet pipe. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING .
  2. Loosen the 3 power steering pump pulley bolts.
  3. Rotate the tensioner and remove the accessory drive belt from the power steering pump pulley.
  4. Remove the 3 bolts and the power steering pump pulley.
    • To install, tighten to 25 Nm (18 lb-ft).
  5. To install, reverse the removal procedure.
    • For additional information on accessory drive belt routing, refer to ACCESSORY DRIVE .
scientia non olet · About LEMON Manuals