General Specifications
WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
GENERAL SPECIFICATIONS
| Item | Specification |
|---|---|
| Differential pinion gear thrust washer thickness | 0.762-0.813 mm (0.030-0.032 in) |
| Differential side gear thrust washer thickness | 1.016-1.067 mm (0.040-0.042 in) |
| Maximum axle shaft end play | 0.762 mm (0.030 in) |
| Maximum differential flange ring gear runout | 0.076 mm (0.003 in) |
| Maximum variation between ring gear teeth | 0.102 mm (0.004 in) |
| Pinion bearing preload | 1.8-3.3 Nm (16-29 lb-in) |
| Ring gear backlash | 0.203-0.304 mm (0.008-0.012 in) |