Differential Carrier: Installation

WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.

Position the differential assembly in the axle housing.

Fig 1: Identifying Differential Carrier Assembly

Courtesy of FORD MOTOR CO.

Install the originally removed differential bearing shim on the LH side.

NOTE: Apply pressure toward the LH side to make sure the LH differential bearing cap is seated.

Install the LH differential bearing cap and loosely install the 2 differential bearing cap bolts.

Fig 2: Locating LH Bearing Cap & Bolts

Courtesy of FORD MOTOR CO.

Install the original differential bearing shim on the RH side.

Fig 3: Identifying Differential Bearing Shim

Courtesy of FORD MOTOR CO.

Using the Shim Driver, fully seat the differential bearing shims.

Fig 4: Seating Differential Bearing Shims Using Special Tool (205-220)

Courtesy of FORD MOTOR CO.

Install the RH side differential bearing cap and tighten the 4 LH side and RH side differential bearing cap bolts.
- Tighten to 105 Nm (77 lb-ft).

Fig 5: Locating Bearing Caps & Bolts

Courtesy of FORD MOTOR CO.

Rotate the differential assembly to make sure it rotates freely.

Fig 6: Rotating Differential Assembly

Courtesy of FORD MOTOR CO.

Measure the ring and pinion backlash.
Install the axle shafts. For additional information, refer to Axle Shaft .