LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1425 (Accessory Drive System) >> Removal And Installation >> Supercharger Belt Idler Pulley >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.

All idler pulleys 

  1. Using a suitable belt tensioner release tool, rotate the Supercharger (SC) belt tensioner clockwise and remove the SC belt from the SC pulley.

    2. Smooth idler pulley 

  2. Remove the bolt and the SC belt smooth idler pulley.
    • To install, tighten to 25 Nm (18 lb-ft).

    3. Grooved idler pulley 

  3. Remove the bolt and the SC belt grooved idler pulley.
    • To install, tighten to 25 Nm (18 lb-ft).

    4. Heavy load idler pulley 

  4. Loosen the coolant pump pulley bolts.
    • To install, tighten to 25 Nm (18 lb-ft).
    5. Fig 1: Locating Coolant Pump Pulley Bolts
    GF0000393Courtesy of FORD MOTOR CO.
  5. Using a suitable belt tensioner release tool, rotate the accessory drive belt tensioner clockwise and remove the accessory drive belt from the coolant pump pulley.
  6. Remove the bolts and the coolant pump pulley.
    7. Fig 2: Locating Coolant Pump Pulley Bolts
    GF0000486Courtesy of FORD MOTOR CO.
  7. Remove the bolt and the SC belt heavy load idler pulley.
    • To install, tighten to 48 Nm (35 lb-ft).

    8. All idler pulleys 

  8. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals