Removal And Installation

WARNING: This page is about a different car, the 2008 Mercury Sable, 2008 Ford Taurus X, and 2008 Ford Taurus. However, it is still accessible from the selected car via links, so may be relevant.

Working in the passenger compartment, pull the carpet out-of-the way, then disconnect the 4X4 control module electrical connector.

Fig 1: Identifying Connector

Courtesy of FORD MOTOR CO.

Disconnect the glove compartment rod. Rotate the glove compartment downward.

Fig 2: Identifying Glove Compartment

Courtesy of FORD MOTOR CO.

Carefully pry the 4X4 control module and bracket assembly from the holding bracket.

Fig 3: Identifying 4X4 Control Module

Courtesy of FORD MOTOR CO.

Remove the 4X4 control module and bracket assembly from the vehicle.
To install, reverse the removal procedure.