LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1371 (Rear Drive Axle/Differential) >> In-Vehicle Servicing >> Stub Shaft Seal >> Removal

Stub Shaft Seal: Removal

WARNING: This page is about a different car, the 2008 Mercury Sable, 2008 Ford Taurus X, and 2008 Ford Taurus. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The rear drive unit (RDU) does not have stub shaft pilot bearings. It has stub shaft seals only.
  1. Remove the halfshaft assembly. For additional information, refer to REAR DRIVE HALFSHAFTS article.
  2. Using the special tools, remove the stub shaft seal.
    3. Fig 1: Removing Stub Shaft Seal
    GF0024591Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals