LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1371 (Rear Drive Axle/Differential) >> In-Vehicle Servicing >> Stub Shaft Seal >> Installation

Stub Shaft Seal: Installation

WARNING: This page is about a different car, the 2008 Mercury Sable, 2008 Ford Taurus X, and 2008 Ford Taurus. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Lubricate the new stub shaft seal with grease.
  1. Using the special tools, install the stub shaft pilot bearing housing seal.
    2. Fig 1: Installing Stub Shaft Pilot Bearing Housing Seal
    GF0024594Courtesy of FORD MOTOR CO.
  2. Install the halfshaft assembly. For additional information, refer to REAR DRIVE HALFSHAFTS article.
scientia non olet · About LEMON Manuals