LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1370 (Parking Brake System And Actuation) >> Removal And Installation >> Parking Brake Control >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Mercury Sable, 2008 Ford Taurus X, and 2008 Ford Taurus. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Release the tension on the parking brake cable. For additional information, refer to Parking Brake Cable Tension Release .
  3. Remove the smart junction box (SJB) and bracket. For additional information, refer to MULTIFUNCTION ELECTRONIC MODULES article.
  4. Disconnect the parking brake switch electrical connector.
  5. Remove the nut and 2 bolts from the parking brake control.
    • To install, tighten to 30 Nm (22 lb-ft).
  6. Position the carpet aside and position the cable conduit grommet through the floor.
  7. Remove the parking brake control from the vehicle.
  8. To install, reverse the removal procedure.
    • Inspect the parking brake system for correct operation.
scientia non olet · About LEMON Manuals