LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1370 (Parking Brake System And Actuation) >> Removal And Installation >> Parking Brake Cable - Intermediate >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Mercury Sable, 2008 Ford Taurus X, and 2008 Ford Taurus. However, it is still accessible from the selected car via links, so may be relevant.
  1. Relieve the parking brake cable tension. For additional information, refer to Parking Brake Cable Tension Release .
  2. Remove the 3 parking brake cable bracket bolts from the subframe.
    • To install, tighten to 12 Nm (9 lb-ft).
  3. Disconnect the intermediate cable from the front cable at the cable-to-cable union.
  4. Release the intermediate cable from the body bracket.
  5. Release the intermediate cable from the rear RH cable at the cable-to-cable union.
  6. Release the LH rear cable from the intermediate cable at the conduit equalizer.
  7. To install, reverse the removal procedure.
    • Inspect the parking brake system for correct operation.
scientia non olet · About LEMON Manuals