Wheel Studs: Removal

WARNING: This page is about a different car, the 2008 Mercury Sable, 2008 Ford Taurus X, and 2008 Ford Taurus. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure may result in major service expense. New parts must be installed with the same part numbers or equivalent part, if replacement is necessary. Do not use a replacement part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct retention of these parts.

NOTE: Make sure the steering wheel is in the unlocked position.

Remove the brake disc. For additional information, refer to FRONT DISC BRAKE article.
Using the C-Frame and Screw Installer/Remover, remove the wheel stud.

Fig 1: Identifying Special Tool (211-023)

Courtesy of FORD MOTOR CO.