LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1361 (HVAC Control System) >> Removal And Installation >> Clutch and Clutch Field Coil >> Removal

Clutch and Clutch Field Coil: Removal

WARNING: This page is about a different car, the 2008 Mercury Sable, 2008 Ford Taurus X, and 2008 Ford Taurus. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the A/C compressor. For additional information, refer to Air Conditioning (A/C) Compressor .
  2. Remove the A/C clutch disc and hub bolt.
    1. Using the Compressor Clutch Holding Tool, hold the A/C clutch disc and hub.
    2. Remove the A/C clutch disc and hub bolt.
    3. Fig 1: A/C Clutch Disc & Hub Bolt
    GF0004394Courtesy of FORD MOTOR CO.
  3. Remove the A/C clutch disc and hub.
  4. Remove the A/C clutch disc and hub spacer(s).
  5. Remove the A/C compressor pulley snap ring.
    6. NOTE: Do not use air tools. Damage to the air conditioning (A/C) clutch pulley or A/C compressor may result.
  6. Remove the A/C compressor pulley.
    1. Install the Compressor Pulley Remover.
    2. Using the Compressor Pulley Remover, remove the A/C compressor pulley.
    7. Fig 2: A/C Compressor Pulley
    GF0004395Courtesy of FORD MOTOR CO.
  7. Remove the A/C clutch field coil snap ring.
  8. Remove the A/C clutch field coil electrical connector bracket screw.
  9. Remove the A/C clutch field coil.
scientia non olet · About LEMON Manuals