Selector Lever Bezel: Installation

WARNING: This page is about a different car, the 2008 Mercury Sable, 2008 Ford Taurus X, and 2008 Ford Taurus. However, it is still accessible from the selected car via links, so may be relevant.

All vehicles

NOTE: Do not lock the 4 selector lever bezel tabs in the selector lever bezel.

Position the selector lever bezel on the selector lever.

Vehicles equipped with a TC switch

Route the TC switch wiring harness through the selector lever bezel and connect the TC switch electrical connector.

Fig 1: Identifying Connector

Courtesy of FORD MOTOR CO.

All vehicles

Install the selector lever bezel light in the selector lever bezel.

Fig 2: Locating Light From PRNDL Bezel

Courtesy of FORD MOTOR CO.

NOTE: Selector lever removed for clarity.

Position the selector lever bezel in place.
- Be sure the 4 tabs are locked in place.

Fig 3: Identifying Tabs

Courtesy of FORD MOTOR CO.

Vehicles not equipped with a TC switch

Position the selector lever knob bezel and the selector lever knob in place.

All vehicles

Position the selector lever knob and knob bezel in place and install the screws.

Fig 4: Identifying Screws

Courtesy of FORD MOTOR CO.

Slide the lower selector lever knob bezel up and snap it into place.

Fig 5: Sliding Lower Selector Lever Knob Bezel Up

Courtesy of FORD MOTOR CO.

Install the upper console panel.

Fig 6: Identifying Upper Console Panel

Courtesy of FORD MOTOR CO.

Install the selector lever bezel trim ring.

Fig 7: Identifying Selector Lever Bezel Trim Ring

Courtesy of FORD MOTOR CO.