Principles of Operation: Notes

WARNING: This page is about a different car, the 2008 Mercury Sable, 2008 Ford Taurus X, and 2008 Ford Taurus. However, it is still accessible from the selected car via links, so may be relevant.

A supplemental restraint system (SRS) consists of a dual stage driver and passenger air bag module, safety belt buckle pretensioners, adaptive load limiting retractors and safety canopies (containing an inflator/squib or gas generator and an air bag), impact sensors, a restraints control module (RCM), a clockspring, an air bag warning indicator, occupant classification sensor (OCS) system and a passenger air bag deactivation (PAD) indicator. These components are all interconnected by a wiring harness and powered by the vehicle's battery. The RCM includes a backup power supply. This feature provides sufficient backup power to deploy the SRS components in the event that the ignition circuit is lost or damaged during impact. The backup power supply will deplete its stored energy approximately one minute after power and/or ground has been removed from the RCM. The RCM performs an internal, external circuitry and component "self-test" during each startup. If a SRS fault exists, the RCM sends a message to instrument cluster module to flash a coded sequence which is called a LFC on the air bag warning indicator. Each LFC is flashed 3 times after which the air bag warning indictor will remain lit for the remainder of the key-on cycle. In addition to the self-test at start up, the RCM continuously monitors all of its external and internal circuitry for faults.

In a frontal collision, the impact sensors located in the front of the vehicle detect the sudden deceleration and send an electrical signal to the RCM. The RCM uses the information from the impact sensors and the OCS system in the deployment determination. If the RCM determines that SRS deployment is required, the RCM sends voltage and current to the squib(s) causing the solid chemical propellant to undergo a rapid chemical reaction. This controlled reaction produces harmless nitrogen gas that fills the air bag(s)/safety canopies and/or activates the safety belt pretensioners/adaptive load limiting retractor(s) to control the tension of the safety belt(s).

The RCM communicates through the data link connector (DLC) the current and historical DTCs on the high-speed controller area network (HS-CAN). The RCM also communicates over the HS-CAN to the instrument cluster module, occupant classification system module (OCSM) and PCM.