LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1349 (Information Center) >> General Procedures >> Belt-Minder® Deactivating/Activating >> Deactivating/Activating

Belt-Minder® Deactivating/Activating: Deactivating/Activating

WARNING: This page is about a different car, the 2008 Mercury Sable, 2008 Ford Taurus X, and 2008 Ford Taurus. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch to the RUN (or ON) position. (Do not start the engine.)
  2. Wait approximately 1 minute until the safety belt warning indicator turns off.
    3. NOTE: Step 3 must be completed within 50 seconds after the safety belt warning indicator turns off.
  3. To disable/enable the seating position, buckle then unbuckle the safety belt 9 times, ending in the unbuckled state.
    • After Step 3, the safety belt warning indicator illuminates for 3 seconds.
  4. Within 10 seconds of the safety belt warning indicator turning on, buckle then unbuckle the safety belt.
    • This disables the Belt-Minder® feature for that seating position, if it is currently enabled. As confirmation, the safety belt warning indicator flashes 4 times per second for 3 seconds.
    • This enables the Belt-Minder® feature for that seating position, if it is currently disabled. As confirmation, the safety belt warning indicator flashes 4 times per second for 3 seconds, followed by 3 seconds with the light off, then followed by the safety belt warning indicator flashing 4 times per second for 3 seconds again.
scientia non olet · About LEMON Manuals