LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1345 (Wiper System And Washer System) >> Diagnostic Tests >> Wipers and Washers >> Principles of Operation >> Windshield Wipers and Washers

Windshield Wipers and Washers

WARNING: This page is about a different car, the 2008 Mercury Sable, 2008 Ford Taurus X, and 2008 Ford Taurus. However, it is still accessible from the selected car via links, so may be relevant.

The windshield wiper system consists of an integrated wiper motor and module assembly, which contains internal washer, run/park and high/low speed relays. The windshield wiper motor and module assembly also contains a Hall-effect sensor that is used to determine the parked position of the wiper motor during a cycle. The integrated windshield wiper motor and module assembly has 5 different operating modes: OFF, LOW speed, HIGH speed, INTERMITTENT and SOFTWARE SAFE mode.

NOTE: The smart junction box (SJB) may also be identified as the generic electronic module (GEM).

If equipped with automatic headlamps, the smart junction box (SJB) will illuminate the exterior lamps, including the parking lamps, when the front wipers are on for more than 3 seconds and the headlamp control is in the AUTOLAMP position. When the wipers are turned off, the exterior lamps will remain on for 30 seconds before turning off.