Removal And Installation

WARNING: This page is about a different car, the 2008 Mercury Sable, 2008 Ford Taurus X, and 2008 Ford Taurus. However, it is still accessible from the selected car via links, so may be relevant.

Place the roof opening panel glass in the full OPEN position.
From top of vehicle, depress spring steel locating tab downward on each side with flat-blade screwdriver while pushing deflector toward rear of vehicle.
- To install, make sure locating tabs are firmly locked in place.

Fig 1: Pressing Spring Steel Tab Downward

Courtesy of FORD MOTOR CO.

Tilt the air deflector upward and pull forward to remove.

Fig 2: Pulling Air Deflector

Courtesy of FORD MOTOR CO.

To install, reverse the removal procedure.
- Initialize the roof opening panel motor. For additional information, refer to Roof Opening Panel Motor Initialization .