LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1341 (Sunroof) >> Diagnostic Tests >> Roof Opening Panel >> Pinpoint Tests >> Pinpoint Test D: The Roof Opening Panel is Noisy During Operation >> Pinpoint Test D: The Roof Opening Panel Is Noisy During Operation

Pinpoint Test D: The Roof Opening Panel Is Noisy During Operation

WARNING: This page is about a different car, the 2008 Mercury Sable, 2008 Ford Taurus X, and 2008 Ford Taurus. However, it is still accessible from the selected car via links, so may be relevant.
  1. D1 CHECK THE ROOF OPENING PANEL FOR OBSTRUCTIONS OR DAMAGE 
    • Check the roof opening panel for any obstructions and damage.
    • Are there any obstructions and/or damage? 
    1. YES  : REMOVE all obstructions. REPAIR any damage. If the damage cannot be repaired, INSTALL a new roof opening panel frame. REFER to Roof Opening Panel - Exploded View  and Roof Opening Panel Frame . TEST the system for normal operation.
    2. NO  : Go to  D2.
  2. D2 CHECK THE ROOF OPENING PANEL OPERATION 
    • Check the roof opening panel during operation.
    • Is the roof opening panel loose or incorrectly adjusted? 
    1. YES  : ADJUST the roof opening panel. REFER to Roof Opening Panel Alignment . TEST the system for normal operation.
    2. NO  : Go to  D3.
  3. D3 CHECK THE ROOF OPENING PANEL TRACKS 
    • Open the roof.
    • Check the roof opening panel tracks for obstructions and damage.
    • Are the roof opening panel tracks OK?  
    1. YES  : Go to  D4.
    2. NO  : REMOVE all obstructions and REPAIR any damage. If the roof opening panel tracks cannot be repaired, INSTALL a new roof opening panel frame. REFER to Roof Opening Panel - Exploded View  and Roof Opening Panel Frame . TEST the system for normal operation.
  4. D4 CHECK THE ROOF OPENING PANEL SHIELD (SUNSHADE) 
    • Check the roof opening panel shield for correct movement.
    • Is the roof opening panel shield moving correctly? 
    1. YES  : Go to  D5.
    2. NO  : REMOVE and REINSTALL the roof opening panel shield. REFER to Roof Opening Panel Shield . TEST the system for normal operation.
  5. D5 CHECK THE ROOF OPENING PANEL LIFTER ASSEMBLIES 
    • Check the roof opening panel lifter assemblies for obstructions and damage.
    • Are the roof opening panel lifter assemblies OK? 
    1. YES  : Go to  D6.
    2. NO  : REMOVE all obstructions and REPAIR any damage. If the roof opening panel lifter assemblies cannot be repaired, INSTALL a new roof opening panel frame. REFER to Roof Opening Panel - Exploded View  (Sunshade) and Roof Opening Panel Frame . TEST the system for normal operation.
  6. D6 CHECK THE ROOF OPENING PANEL MOTOR/MODULE 
    • Remove the roof opening panel motor/module and leave the electrical connector connected.
    • Operate the roof opening panel to the full OPEN and CLOSED position.
    • Does the motor/module make excessive noise? 
    1. YES  : INSTALL a new roof opening panel motor/module. REFER to Roof Opening Panel - Exploded View  and Roof Opening Panel Motor . TEST the system for normal operation.
    2. NO  : REINSTALL the roof opening panel motor/module. TEST the system for normal operation. If the roof opening panel is still noisy, INSTALL a new roof opening panel frame. Roof Opening Panel - Exploded View  and Roof Opening Panel Frame . If the roof opening panel is no longer noisy, the system is operating correctly. The concern may have been caused by an incorrectly installed roof opening panel motor.
scientia non olet · About LEMON Manuals