Power Liftgate Operation

The following is a brief explanation of a normal power open cycle of the power liftgate.

• The power open operation will begin with one of the following methods:
  • The LTM receives a momentary ground signal from the power liftgate control switch.
  • The SJB receives a signal from the remote transmitter key fob (double button press).
  • The LTM receives a signal from the SJB indicating the exterior liftgate handle has been activated.
• The LTM checks the PRNDL position and vehicle speed status from the CAN communication link.
• The LTM supplies power to the unlatch/cinching motor until the sector gear switches indicate end of travel which releases the power liftgate latch.
• The power liftgate detent switch, primary forkbolt switch and secondary forkbolt switch circuits are monitored for correct latch release signals.
• Power is supplied to the drive assembly actuator clutch and motor, opening the power liftgate.
• The power liftgate supplies power to the unlatch/cinching motor while monitoring the sector gear switches to return the sector gear to the neutral position.
• When the power liftgate is opening, the position sensor is monitored for liftgate position and velocity. If an obstruction is detected, the liftgate will stop.
• The power liftgate full open position is learned by the LTM during the power liftgate initialization. When the power liftgate reaches the full open position, the LTM removes the power from the drive assembly actuator motor and clutch.
• After the power is removed from the clutch and drive motor, the position sensor briefly continues to monitor the position of the liftgate. If excessive movement in the closed direction is detected, power is reapplied to the clutch and a continuous chime is initiated and remains on as the liftgate is automatically power closed.
• If the excessive closing movement is detected on 11 successive power open requests, DTC B201A is set and power liftgate operation is disabled until the DTC is cleared.

The following is a brief explanation of a normal power close cycle of the power liftgate.

• The power close operation will begin with one of the following methods:
  • The LTM receives a momentary ground signal from the power liftgate control switch.
  • The LTM receives a momentary ground signal from the power liftgate rear control switch (LH rear quarter panel).
  • The SJB receives a signal from the remote transmitter key fob (double press).
• The LTM checks the PRNDL position and vehicle speed status from the CAN communication link.
• The LTM will start an audible chime.
• After one second of audible chime, power is supplied to the drive assembly actuator clutch and motor as the audible chime continues 3 seconds total.
• As the power liftgate is powered closed, the position sensor is monitored for liftgate position and velocity. The power liftgate will reverse if an obstruction is detected.
• Also, as the power liftgate is powered closed, the pinch strips are monitored for a pinch condition. The power liftgate will reverse if an obstruction is detected by either pinch strip.
• The power liftgate detent switch, forkbolt primary switch and forkbolt secondary switch circuits are monitored for correct latch signals.
• When the LTM receives switch signals indicating the secondary latch position is reached, power is supplied to the unlatch/cinching motor to pull the liftgate into the primary latch position. When primary latch position is reached, power is removed from the drive motor and clutch.
• When the LTM receives switch signals indicating the primary latch position has been reached (liftgate is fully closed), the LTM reverses the direction of the unlatch/cinching motor until the sector gear switches indicate the neutral position.