Power Liftgate Awake/Sleep Status
WARNING: This page is about a different car, the 2008 Mercury Sable, 2008 Ford Taurus X, and 2008 Ford Taurus. However, it is still accessible from the selected car via links, so may be relevant.
- The LTM is in the awake state whenever the ignition is in the RUN position.
- The LTM is in the awake state while carrying out a close or an open operation, including cinch.
- The LTM is in the sleep state when all of the following conditions exist:
- The latch is not in the fully unlatched position.
- The ignition is in the OFF position.
- No power operation is active.
- No wakeup inputs have changed state for more than 20 seconds.
- The LTM is also in the sleep state when all of the following conditions exist:
- The latch is in the unlatched position.
- The ignition is in the OFF position.
- No power operation is active.
- No wakeup inputs have changed state for more than 6 hours.
The wakeup inputs for the power liftgate are:
- Power liftgate open/close switch request signal
- Forkbolt primary signal
- Forkbolt secondary signal
- Detent switch signal
- Rear control switch
- Exterior handle switch
- Glass ajar switch
- CAN