LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 133 (Rear Disc Brake System) >> Removal And Installation >> Rear Disc Brake >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
    2. CAUTION: When removing the brake caliper anchor plate, never allow it to hang from the brake hose. Provide a suitable support.
  2. Remove the brake caliper anchor plate bolts and discard. Position the brake caliper anchor plate aside.
    • To install, tighten to 110 Nm (81 lb-ft).
  3. Remove and discard the brake disc screw.
    • To install, tighten to 21 Nm (15 lb-ft).
  4. Remove the brake disc.
  5. To install, reverse the removal procedure, using 2 new brake caliper anchor plate bolts.
scientia non olet · About LEMON Manuals