LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1307 (Front Disc Brake System) >> Removal And Installation >> Front Brake Caliper Anchor Plate >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the wheel and tire. For additional information, refer to WHEELS AND TIRES article.
  2. Release the wheel speed sensor wiring harness from the brake flexible hose.
    3. Fig 1: Speed Sensor Wiring Retainers
    GF0012243Courtesy of FORD MOTOR CO.
    CAUTION: Do not allow the caliper to hang from the brake hose or damage to the hose can occur.
  3. Remove the 2 brake caliper guide pin bolts and position the caliper aside.
    • Support the caliper using mechanic's wire.
    • To install, tighten to 37 Nm (27 lb-ft).
  4. Remove the brake pads from the anchor plate.
  5. Remove the 2 brake caliper anchor plate bolts and the brake caliper anchor plate.
    • To install, tighten to 265 Nm (195 lb-ft).
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals